Select F2 “job” select SG_CODIEREN and press okĢ2. That INPA package contains INPA 4.4.7, the EDIABAS 6.4.3 API (which is required for most of the tools), NCSExpert 3.0.8, WinELDI 2.6.1, NCS plant 3.0.5, NFS 4.2, WinKFP 4.2, & ToolSet32 3.2. We need to change that to a coding function because we want to write the changes to the module.Ģ1. On the same page, you can select the option to install NCS Expert and WINKFP in addition to INPA and EDIABAS (its not required now, but its useful for later). Ok now take a look where it says “JOBNAME = CODIERDATEN_LESEN”Ģ0. You will see a screen similar to this just press ok.įile:///C:/Users/Tim/Documents/BMW%20Software/Diagnostic_cable/ReadMe/untitled12.jpgįile:///C:/Users/Tim/Documents/BMW%20Software/Diagnostic_cable/ReadMe/untitled13.jpgġ9. you are basically telling NCS to read all the valuesįrom your FSW_PSW.MAN file. Back to NCS now hit F5 for basic functionsġ6. Search for the option “BC_DIGITAL_V” and change the value from “nicht_aktiv” to “aktiv”ġ5. I didn't do this with the first two modules I coded and it seemed to work fine - is this necessary with some modules but not others?ġ3. He has the added step below of selecting 'coapiReadSgGetFswPsw', which I had also seen something about on some of the videos. Then I was getting ready to do the digital speedo in KMB, so I was reading the instructions for that in the ReadMe file that came with the software from the Romanian guy. In the work folder you will see the trc file. The default here is SG_codiren which is write, you need to select, codiren lessen, which is read. Pick the gm3 for example, then select OKġ0. Hit f4 to bring up the module specific menu (Process ECU)ĩ. Now you have to start reading the modules. Pick EWS to read your vin into the systemħ. Connect cable to car, turn key to position 2, start INPAĥ.

Ncs expert lcm option